خرید و دانلود نسخه کامل کتاب Programming the Propeller with Spin: A Beginner’s Guide to Parallel Processing (Tab Electronics)

Parallel Processing With the Propeller–Made Easy!”This book should find a place on any Propellerhead’s bookshelf, between Parallax’s Propeller Manual and its Programming and Customizing the Multicore Propeller volumes.” Make: 24Programming the Propeller with Spin: A Beginner’s Guide to Parallel Processing walks you through the essential skills you need to build and control devices using the Propeller chip and its parallel processing environment. Find out how to use each of the identical 32-bit processors, known as cogs, and make the eight cogs effectively interact with each other. The book covers Propeller hardware and software setup, memory, and the Spin language. Step-by-step projects give you hands-on experience as you learn how to:Use Propeller I/O techniques with extensive Spin code examplesDisplay numbers with seven segment displaysCreate accurate, controlled pulse sequencesAdd a 16 character by two line LCO displayControl R/C hobby servosUse motor amplifiers to control small motorsRun a bipolar stepper motorBuild a gravity sensor-based auto-leveling tableRun DC motors with incremental encodersRun small AC motorsYou’ll also find hundreds of lines of ready-to-run documented Spin code as well as PDFs of all the schematics on McGraw-Hill’s website: Downloads available at www.mhprofessional.com/computingdownload”This book should find a place on any Propellerhead’s bookshelf, between Parallax’s Propeller Manual and its Programming and Customizing the Multicore Propeller volumes.” Make: 24